ZH
*RIGHT POWER MIRROR INOPERATIVE (CONTINUED)
3.
MEASURE RIGHT POWER MIRROR HORIZONTAL MOTOR CIRCUIT RESISTANCE
Turn the ignition off.
Disconnect all jumper wires.
Disconnect the Right Power Mirror pigtail harness connector.
Note: The Power Mirror pigtail harness connector can be
accessed by removing the small square access panel located at
the top front corner of the door panel.
Note: Check connectors - Clean/repair as necessary.
Connect a jumper wire between cavity 5 and cavity 6 of the Right
Power Mirror pigtail harness connector.
Measure the resistance between cavity 4 and cavity 8 of the Power
Mirror Switch harness connector.
Is the resistance below 5.0 ohms?
Yes
>> Replace the Right Power Mirror. (Refer to 8 - ELECTRI-
CAL/POWER
REMOVAL).
Perform BODY VERIFICATION TEST.
No
>> Repair the Right Power Mirror Horizontal Motor circuit for
an open.
Perform BODY VERIFICATION TEST.
4.
MEASURE RIGHT POWER MIRROR VERTICAL MOTOR CIRCUIT RESISTANCE
Turn the ignition off.
Disconnect all jumper wires.
Disconnect the Right Power Mirror pigtail harness connector.
Note: The Power Mirror pigtail harness connector can be
accessed by removing the small square access panel located at
the top front corner of the door panel.
Note: Check connectors - Clean/repair as necessary.
Connect a jumper wire between cavity 5 and cavity 4 of the Right
Power Mirror pigtail harness connector.
Measure the resistance between cavity 4 and cavity 5 of the Power
Mirror Switch harness connector.
Is the resistance below 5.0 ohms?
Yes
>> Replace the Right Power Mirror. (Refer to 8 - ELECTRI-
CAL/POWER
REMOVAL).
Perform BODY VERIFICATION TEST.
No
>> Repair the Right Power Mirror Vertical Motor circuit for an
open.
Perform BODY VERIFICATION TEST.
POWER MIRRORS - ELECTRICAL DIAGNOSTICS 8N - 57
MIRRORS/SIDEVIEW
MIRRORS/SIDEVIEW
MIRROR
-
MIRROR
-