Chrysler 2005 Crossfire SRT6 Service Manual page 1633

ZH
6. Remove the three wiper motor retaining bolts (1)
from the wiper module (2).
7. Remove the wiper motor (3) from the wiper module
(2).
INSTALLATION
Before installing the wiper motor, synchronize the wiper motor shaft into the park position. (Refer to 8 - ELECTRI-
CAL/WIPERS/WASHERS/FRONT WIPER MOTOR - STANDARD PROCEDURE).
1. Insert the wiper motor (3) into the wiper motor module (2).
2. Install the three wiper motor retaining bolts (1). Tighten bolts to 11 N·m (8 ft. lbs.).
3. Align the wiper motor crank arm (1) onto the wiper
motor shaft in the park position (3) and press into
place.
4. Install the wiper motor crank arm retaining nut (2).
Tighten retaining nut to 26 N·m (19 ft. lbs.).
5. Install the wiper motor module into the vehicle.
(Refer to 8 - ELECTRICAL/WIPERS/WASHERS/
WIPER MODULE - INSTALLATION).
6. Connect the negative battery cable.
WIPERS/WASHERS - SERVICE INFORMATION 8R - 63