Chrysler 2005 Crossfire SRT6 Service Manual page 1457

ZH
2. Disconnect the negative battery cable (2). Wait two
minutes for the system capacitor to discharge
before further service.
3. From the underside of the steering wheel, remove
the two screws (1) that secure the driver airbag to
the steering wheel.
4. Pull the driver airbag away from the steering wheel far enough to access the electrical connections to the steer-
ing wheel.(ART)
5. Disconnect the steering wheel wire harness connectors for the horn switch.
6. Disconnect the clockspring driver airbag pigtail harness connectors.
CAUTION: Do not pull on the clockspring pigtail wires or pry on the connector insulator to disengage the
connector from the driver airbag inflator connector receptacle. Improper removal of these pigtail wires and
their connector insulators can result in damage to the airbag circuits or connector insulators.
7. Remove the driver airbag from the steering wheel.
WARNING: DO NOT PLACE AN INTACT UNDEPLOYED AIRBAG FACE DOWN ON A HARD SURFACE, THE
AIRBAG WILL PROPEL INTO THE AIR IF ACCIDENTALLY DEPLOYED.
RESTRAINTS - SERVICE INFORMATION 8O - 101