Chrysler 2005 Crossfire SRT6 Service Manual page 670

8A - 16 AUDIO - ELECTRICAL DIAGNOSTICS
*NO SOUND FROM RIGHT REAR SPEAKER (CONTINUED)
AMPLIFIED RIGHT REAR SPEAKER (+) CIRCUIT OPEN
AMPLIFIED RIGHT REAR SPEAKER (-) CIRCUIT OPEN
RIGHT REAR SPEAKER SUPPLY VOLTAGE CIRCUIT OPEN
RIGHT REAR SPEAKER GROUND CIRCUIT OPEN
RIGHT REAR SPEAKER
For a complete Audio System Circuit Diagram, (Refer to 8 - ELECTRICAL/AUDIO - SCHEMATICS AND DIA-
GRAMS).
Diagnostic Test
1.
MEASURE RIGHT REAR SPEAKER CIRCUIT RESISTANCE
Turn the ignition off.
Disconnect the Power Amplifier harness connector.
Note: Check connectors - Clean/repair as necessary.
Disconnect the Right Rear Speaker harness connector.
Note: Check connectors - Clean/repair as necessary.
Connect a jumper wire between cavity 1 and cavity 2 of the Right
Rear Speaker harness connector.
Measure the resistance between cavity 5 (connector B) and cavity 15
(connector B) of the Power Amplifier harness connector.
Is the resistance below 5.0 ohms?
Yes >> Go to 2
No >> Repair the Amplified Right Rear Speaker (+) or (-) circuit
for an open.
Perform BODY VERIFICATION TEST.
POSSIBLE CAUSES
ZH