Chrysler 2005 Crossfire SRT6 Service Manual page 909

ZH
*HORNS INOPERATIVE (CONTINUED)
HORN SWITCH CIRCUIT OPEN
RELAY CONTROL MODULE
GROUND CIRCUIT OPEN
HORN(S)
For a complete Horn Circuit Diagram, (Refer to 8 - ELECTRICAL/HORN - SCHEMATICS AND DIAGRAMS).
Diagnostic Test
1.
TEST THE HORNS
Note: Inspect the Horn Fuse (F6) located in the Relay Control
Module. If the fuse is open, repair the cause of the open fuse
before continuing.
Turn the ignition off.
Disconnect the Relay Control Module connector "E".
Note: Check connectors - Clean/repair as necessary.
Connect a fused jumper wire from cavity 1 of the Relay Control Mod-
ule connector "E" to B(+).
Did the Horns sound?
Yes >> Go to 4
No >> Go to 2
HORN - ELECTRICAL DIAGNOSTICS 8H - 3
POSSIBLE CAUSES