Chrysler 2005 Crossfire SRT6 Service Manual page 701

ZH
CONDITION
NO KEY IN IGNITION OR
HEADLAMPS-ON WARNING
CHIME WITH DRIVER SIDE
DOOR OPEN
CHIME SOUNDS WITH
DRIVER SIDE FRONT
DOOR OPEN
NO CHIMES AT ALL TIMES
OPERATION
The chime warning system components operate on battery voltage received through fuse 35 in the Underhood
Accessory Fuse Block on a non-switched B(+) circuit so that the system may operate regardless of the ignition
switch position.
The chime warning system provides an audible indication to the vehicle operator under the following conditions:
• Fasten Seat Belt Warning - The Instrument Cluster chime tone generator will generate repetitive chimes to
announce that an input from the seat belt switch indicates the driver side seat belt is not fastened. Unless the
driver side seat belt is fastened, the chimes will continue to sound for a short duration each time the ignition
switch is turned to the ON/RUN position or until the driver side seat belt is fastened.
• Head/Park Lights-On Warning - The Instrument Cluster chime tone generator will generate repetitive chimes
to indicate that the exterior lamps are turned On with the driver side door opened. The chime will continue to
sound until the exterior lamps are turned Off, the driver side door is closed, or the ignition switch is turned to
the ON/RUN position.
• Key-In-Ignition Warning - The Instrument Cluster chime tone generator will generate repetitive chimes at a
fast rate to indicate that the key is in the ignition cylinder with the driver side door opened and the ignition
switch in the OFF/LOCK position. The chime will continue to sound until the key is removed from the ignition
lock cylinder, the driver side door is closed, or the ignition switch is turned to the ON/RUN position.
POSSIBLE CAUSES
1. Faulty door ajar switch or
circuits.
2. Faulty headlamp switch
(illumination control module)
or circuits.
3. Key in ignition switch
sense circuit open.
4. Faulty ignition switch.
1. Key in ignition switch
sense circuit shorted.
2. Faulty ignition switch.
1. Faulty Instrument Cluster.
CHIME/BUZZER - SERVICE INFORMATION 8B - 5
CORRECTION
1. Check that interior lights illuminate with the
driver door open. If not OK, repair the interior
lighting system as required.
2. Check for proper exterior lighting operation. If
not OK, repair the exterior lighting system as
required.
2. Check for continuity between the key in ignition
switch sense circuit of the instrument panel wire
harness connector for the ignition switch and the
body wire harness connector for the underhood
accessory fuse block. Repair the key in ignition
switch sense circuit, if required.
3. Check for continuity between the two terminals
in the ignition switch connector. There should be
continuity with a key in the ignition lock cylinder.
Replace the faulty ignition switch, if required.
1. Disconnect the instrument panel wire harness
connector for the ignition switch and the body
wire harness connector for the underhood
accessory fuse block. There should be no
continuity between the key in ignition switch
sense circuit of the instrument panel wire harness
connector for the ignition switch and a good
ground. Repair the key in ignition switch sense
circuit, if required.
2. Check for continuity between the two terminals
in the ignition switch connector. There should be
no continuity with the key removed from the
ignition lock cylinder. Replace the faulty ignition
switch, if required.
1. Use a DRB III scan tool and refer to the
appropriate diagnostic information. Replace the
faulty Instrument Cluster, if required