Chrysler 2005 Crossfire SRT6 Service Manual page 1082

8L - 16 LAMPS/LIGHTING - EXTERIOR - ELECTRICAL DIAGNOSTICS
*RIGHT PARK LAMP INOPERATIVE (CONTINUED)
3.
MEASURE RIGHT PARK LAMP VOLTAGE
Connect the Illumination Control Module harness connector.
Turn the ignition on.
Turn the park lamps on.
Measure the voltage between the Right Park Lamp harness connector
cavity 2 and ground.
Is voltage present?
Yes >> Go to 4
No >> Replace the Illumination Control Module. (Refer to 8 -
ELECTRICAL/LAMPS/LIGHTING
LAMP SWITCH - REMOVAL).
Perform BODY VERIFICATION TEST.
4.
MEASURE RIGHT PARK LAMP GROUND CIRCUIT RESISTANCE
Turn the ignition off.
Turn the park lamps off.
Measure the resistance between the Right Park Lamp harness con-
nector cavity 1 and ground.
Is the resistance below 5.0 ohms?
Yes >> Ensure that the Right Park Lamp bulb is installed properly
and replace the bulb socket if necessary.
Perform BODY VERIFICATION TEST.
No >> Repair the Right Park Lamp ground circuit for an open.
Perform BODY VERIFICATION TEST.
- EXTERIOR/HEAD-
ZH