Chrysler 2005 Crossfire SRT6 Service Manual page 759

ZH
*NO RESPONSE FROM BODY CONTROL MODULE (CONTINUED)
5.
GROUND CIRCUIT(S) OPEN
Turn the ignition off.
Measure the resistance of the Ground circuits from the BCM C4 har-
ness connector to ground.
Is the resistance below 5.0 ohms?
Yes >> Go to 6
No >> Repair the Ground circuit(s) for an open.
Perform BODY VERIFICATION TEST.
6.
SCI TRANSMIT CIRCUIT OPEN
With the ignition off.
Measure the resistance of the SCI Transmit circuit from the BCM C4
harness connector to the DLC.
Is the resistance below 5.0 ohms?
Yes >> Replace the Body Control Module. (Refer to 8 - ELECTRI-
CAL/ELECTRONIC CONTROL MODULES/BODY CON-
TROL/CENTRAL TIMER MODUL - REMOVAL) .
Perform BODY VERIFICATION TEST.
No >> Repair the SCI Transmit circuit for an open.
Perform BODY VERIFICATION TEST.
ELECTRONIC CONTROL MODULES - ELECTRICAL DIAGNOSTICS 8E - 57