Chrysler 2005 Crossfire SRT6 Service Manual page 1345

ZH
*RIGHT FRONT POWER WINDOW INOPERATIVE (CONTINUED)
RIGHT FRONT POWER WINDOW SWITCH
RIGHT POWER WINDOW SWITCH SENSE CIRCUIT
GROUND CIRCUIT
RIGHT FRONT POWER WINDOW MOTOR
RIGHT FRONT POWER WINDOW DRIVER CIRCUIT
BODY CONTROL MODULE
For a complete Power Windows Circuit Diagram, (Refer to 8 - ELECTRICAL/POWER WINDOWS - SCHEMATICS
AND DIAGRAMS).
Diagnostic Test
1.
CHECKING THE RIGHT FRONT POWER WINDOW SWITCH
Turn the ignition on.
Push and hold the Right Power Window Switch to roll down the win-
dow.
While holding the Right Front Power Window Switch down and then
up, measure the voltage of the Right Power Window Switch Sense cir-
cuit by backprobing the Right Front Power Window Switch harness
connector.
Is the voltage between 8.0 - 9.0 volts rolling the window down
and between 4.0 - 5.0 volts rolling the window up?
Yes >> Go to 5
Perform BODY VERIFICATION TEST.
No >> Go to 2
2.
MEASURE THE VOLTAGE OF THE RIGHT POWER WINDOW SWITCH SENSE CIRCUIT
Release the Right Power Window Switch.
Turn the ignition off.
Disconnect the Right Front Power Window Switch harness connector.
Note: Check connectors - Clean/repair as necessary.
Turn the ignition on.
Measure the voltage of the Right Power Window Switch Sense circuit
at the Right Front Power Window Switch harness connector.
Is the voltage above 10 volts?
Yes >> Go to 4
No >> Go to 3
POWER WINDOWS - ELECTRICAL DIAGNOSTICS 8N - 115
POSSIBLE CAUSES