Chrysler 2005 Crossfire SRT6 Service Manual page 1581

ZH
*WASHERS RUN CONTINUOUSLY WITH IGNITION ON (CONTINUED)
MULTI-FUNCTION SWITCH
WASHER PUMP MOTOR CONTROL CIRCUIT SHORT TO VOLTAGE
BODY CONTROL MODULE
For a complete Wipers/Washers Circuit Diagram, (Refer to 8 - ELECTRICAL/WIPERS/WASHERS - SCHEMATICS
AND DIAGRAMS).
Diagnostic Test
1.
MEASURE MULTI-FUNCTION SWITCH RESISTANCE
Note: If any BCM DTCs are set, diagnose them first before con-
tinuing.
Disconnect the BCM harness connector.
Note: Check connectors - Clean/repair as necessary.
Disconnect the Multi-Function Switch harness connector.
Note: Check connectors - Clean/repair as necessary.
Turn the ignition on.
Measure the voltage of the Washer Pump Motor Control circuit at cav-
ity 8 of the Multi-Function Switch harness connector.
Is voltage present?
Yes >> Repair the Washer Pump Motor Control circuit for an
open.
Perform BODY VERIFICATION TEST.
No >> Go to 2
WIPERS/WASHERS - ELECTRICAL DIAGNOSTICS 8R - 11
POSSIBLE CAUSES