Chrysler 2005 Crossfire SRT6 Service Manual page 1403

ZH
AIRBAG WARNING INDICATOR CIRCUIT (CONTINUED)
When Monitored and Set Condition
• When Monitored: With the ignition on. The Occupant Restraint Controller (ORC) monitors the status of the
Airbag Warning Indicator Driver circuit.
• Set Condition: The DTC will set if the Airbag Warning Indicator Driver circuit is open or short.
FUSED B(+) CIRCUIT OPEN
AIRBAG WARNING INDICATOR DRIVER CIRCUIT OPEN
AIRBAG WARNING INDICATOR DRIVER CIRCUIT SHORT
INDICATOR LIGHT
OCCUPANT RESTRAINT CONTROLLER
For a complete Restraints System Circuit Diagram, (Refer to 8 - ELECTRICAL/RESTRAINTS - SCHEMATICS AND
DIAGRAMS).
Diagnostic Test
1.
INSPECT THE AIRBAG WARNING INDICATOR LAMP BULB
Note: Inspect Fuse 3 located in the Underhood Accessory Fuse Block. If the fuse is open, repair the cause
of the open first before continuing.
Note: When reconnecting the Airbag System components, the ignition must be turned off and the battery
must be disconnected.
Turn the ignition off.
Remove the Airbag Warning Indicator Lamp Bulb from the Instrument Cluster and inspect for an open filament.
Is the Bulb filament open?
Yes >> Replace the Airbag Warning Indicator Lamp bulb. (Refer to 8 - ELECTRICAL/INSTRUMENT CLUSTER
- STANDARD PROCEDURE).
Perform AIRBAG VERIFICATION TEST.
No >> Go to 2
2.
MEASURE INSTRUMENT CLUSTER VOLTAGE
With the ignition off.
Disconnect the Instrument Cluster harness connector.
Note: Check connectors - Clean/repair as necessary.
Turn the ignition on.
Measure the voltage of the Fused B(+) circuit at the Instrument Cluster
harness connector.
Is the voltage above 11 volts?
Yes >> Go to 3
No >> Repair the Fused B(+) circuit for an open.
Perform AIRBAG VERIFICATION TEST.
RESTRAINTS - ELECTRICAL DIAGNOSTICS 8O - 47
POSSIBLE CAUSES