Chrysler 2005 Crossfire SRT6 Service Manual page 1478

8O - 122 RESTRAINTS - SERVICE INFORMATION
11. Temporarily reconnect the negative battery cable.
12. Move the seat to the full rearward position.
13. Disconnect the negative battery cable again.
14. Install the seat track front bolts (1). Tighten the
front bolts to 50 N·m (37 ft. lbs.).
15. Install the door sill plate by pushing it firmly down
onto the retaining clips.
16. Install the ignition key.
17. Do not reconnect the negative battery cable at
this time. Perform the Supplemental Restraint
System verification test procedure after servicing
any Supplemental Restraint System component.
(Refer to 8 - ELECTRICAL/RESTRAINTS - STAN-
DARD PROCEDURE).
ZH