Table of Contents
Advertisement
ZH
*SEAT BELT INDICATOR INOPERATIVE (CONTINUED)
INDICATOR CIRCUIT OPEN
INDICATOR LAMP
DRIVER SEAT BELT SWITCH
INSTRUMENT CLUSTER
For a complete Instrument Cluster Circuit Diagram, (Refer to 8 - ELECTRICAL/INSTRUMENT CLUSTER - SCHE-
MATICS AND DIAGRAMS).
Diagnostic Test
1.
SEAT BELT INDICATOR SWITCH
Turn the ignition off.
Disconnect the Seat Belt Indicator Switch harness connector.
Note: Check connectors — Clean/repair as necessary.
Connect a jumper wire between cavity 1 and cavity 2 of the Driver
Seat Belt Switch harness connector.
Turn the ignition on.
Is the Seat Belt Indicator Lamp on?
Yes
>> Replace the Seat Belt Indicator Switch.(Refer to 8 - ELEC-
TRICAL/RESTRAINTS/SEAT BELT BUCKLE - REMOVAL)
Perform BODY VERIFICATION TEST.
No
>> Go to 2
2.
SEAT BELT INDICATOR CIRCUIT
Turn the ignition off.
Disconnect the Instrument Cluster C2 harness connector.
Note: Check connectors — Clean/repair as necessary.
Measure the resistance between ground and the Seat Belt Indicator
circuit.
Is the resistance below 5.0 ohms?
Yes
>> Check the Seat Belt Indicator lamp. If the lamp is OK,
replace the Instrument Cluster. (Refer to 8 - ELECTRICAL/
INSTRUMENT CLUSTER - REMOVAL).
Perform BODY VERIFICATION TEST.
No
>> Repair the Seat Belt Indicator circuit for an open.
Perform BODY VERIFICATION TEST.
INSTRUMENT CLUSTER - ELECTRICAL DIAGNOSTICS 8J - 59
POSSIBLE CAUSES
Advertisement
Chapters
Table of Contents
