Chrysler 2005 Crossfire SRT6 Service Manual page 1476

8O - 120 RESTRAINTS - SERVICE INFORMATION
15. Install the door sill plate (1) by pushing it firmly
down onto the retaining clips.
16. Install the ignition key.
17. Do not reconnect the negative battery cable at
this time. Perform the Supplemental Restraint
System verification test procedure after servicing
any Supplemental Restraint System component.
(Refer to 8 - ELECTRICAL/RESTRAINTS - STAN-
DARD PROCEDURE).
INSTALLATION — RIGHT SIDE
1. Verify the negative battery cable (2) is discon-
nected before proceeding. Wait two minutes for
the system capacitor to discharge before fur-
ther service.
ZH