Chrysler 2005 Crossfire SRT6 Service Manual page 1364

Table of Contents

Advertisement

8O - 8
RESTRAINTS - ELECTRICAL DIAGNOSTICS
DRIVER AIRBAG SQUIB CIRCUIT (CONTINUED)
6.
MEASURE THE RESISTANCE OF THE DRIVER SQUIB CIRCUITS
WARNING: TURN THE IGNITION OFF, DISCONNECT THE BAT-
TERY AND WAIT TWO MINUTES BEFORE PROCEEDING.
Measure the resistance between the Driver Squib Line 1 circuit and
the Driver Squib Line 2 circuit at the Clockspring connector.
Is the resistance below 10K ohms?
Yes
>> Repair the Driver Squib circuits for a short to each other.
Perform AIRBAG VERIFICATION TEST.
Note: When reconnecting the Airbag System components, the
ignition must be turned off and the battery must be disconnected.
No
>> Go to 7
7.
MEASURE THE VOLTAGE OF THE DRIVER SQUIB LINE 1 CIRCUIT
WARNING: TURN THE IGNITION OFF, DISCONNECT THE BAT-
TERY AND WAIT TWO MINUTES BEFORE PROCEEDING.
WARNING: TURN THE IGNITION ON, THEN RECONNECT THE
BATTERY.
Measure the voltage of the Driver Squib Line 1 circuit at the Clock-
spring 2–wire connector.
Is voltage present?
Yes
>> Repair the Driver Squib Line 1 circuit for a short to volt-
age.
Perform AIRBAG VERIFICATION TEST.
Note: When reconnecting the Airbag System components, the
ignition must be turned off and the battery must be disconnected.
No
>> Go to 8
8.
MEASURE THE VOLTAGE OF THE DRIVER SQUIB LINE 2 CIRCUIT
With the ignition on.
Measure the voltage of the Driver Squib Line 2 circuit at the Clock-
spring 2–wire connector.
Is voltage present?
Yes
>> Repair the Driver Squib Line 2 circuit for a short to volt-
age.
Perform AIRBAG VERIFICATION TEST.
Note: When reconnecting the Airbag System components, the
ignition must be turned off and the battery must be disconnected.
No
>> Go to 9
ZH

Advertisement

Table of Contents
loading

Table of Contents