Chrysler 2005 Crossfire SRT6 Service Manual page 1645

ZH
STANDARD PROCEDURE
ELECTROSTATIC DISCHARGE (ESD) SENSITIVE DEVICES
All ESD sensitive components are solid state and a
symbol is used to indicate this. When handling any
component with this symbol, comply with the following
procedures to reduce the possibility of electrostatic
charge build up on the body and inadvertent discharge
into the component. If it is not known whether the part
is ESD sensitive, assume that it is.
1. Always touch a known good ground before han-
dling the part. This should be repeated while han-
dling the part and more frequently after sliding
across a seat, sitting down from a standing posi-
tion, or walking a distance.
2. Avoid touching electrical terminals of the part,
unless instructed to do so by a written procedure.
3. When using a voltmeter, be sure to connect the
ground lead first.
4. Do not remove the part form it's protective packing
until it is time to install the part.
5. Before removing the part from it's pakage, ground
the pakage to a known good ground on the vehicle.
TESTING OF VOLTAGE POTENTIAL
1. Connect the ground lead of a voltmeter to a known
good ground.
2. Connect the other lead of the voltmeter to the
selected test point. The vehicle ignition may need
to be turned ON to check voltage. Refer to the
appropriate test procedure.
8W-01 WIRING DIAGRAM INFORMATION 8W - 01 - 9