Chrysler 2005 Crossfire SRT6 Service Manual page 1343

ZH
*LEFT FRONT POWER WINDOW INOPERATIVE (CONTINUED)
5.
TEST THE LEFT FRONT POWER WINDOW MOTOR
Turn the ignition off.
Disconnect the Body Control Module (BCM) C4 harness connector.
Note: Check connectors - Clean/repair as necessary.
Connect a fused jumper wire from cavity 12 of the BCM C4 harness
connector to B(+).
Connect a second fused jumper wire to cavity 13 of the BCM harness
connector and momentarily connect the jumper to ground.
Note the window movement; if the left front window does not move,
reverse the jumper wires at the B(+) and ground connections.
Did the left front window move upward or downward?
Yes >> Replace the Body Control Module. (Refer to 8 - ELECTRI-
CAL/ELECTRONIC CONTROL MODULES/BODY CON-
TROL/CENTRAL TIMER MODUL - REMOVAL).
Perform BODY VERIFICATION TEST.
No >> Go to 6
6.
MEASURE LEFT FRONT POWER WINDOW DRIVER CIRCUITS RESISTANCE
With the ignition off.
Disconnect the Left Front Power Window Motor harness connector.
Note: Check connectors - Clean/repair as necessary.
Connect a jumper wire between cavity 1 and cavity 2 of the Left Front
Power Window Motor harness connector.
Measure the resistance between cavity 12 and cavity 13 of the BCM
C4 harness connector.
Is the resistance below 5.0 ohms?
Yes >> Replace the Left Front Power Window Motor. (Refer to 8 -
ELECTRICAL/POWER WINDOWS/WINDOW MOTOR -
REMOVAL).
Perform BODY VERIFICATION TEST.
No >> Repair the Left Front Power Window Driver circuit for an
open.
Perform BODY VERIFICATION TEST.
POWER WINDOWS - ELECTRICAL DIAGNOSTICS 8N - 113