Chrysler 2005 Crossfire SRT6 Service Manual page 1564

8Q - 58 VEHICLE THEFT SECURITY - SERVICE INFORMATION
Note: Before disassembly, note the wire harness
routing for proper reassembly.
3. Pull to remove the sentry key antenna ring (1) from
the ignition switch key cylinder (2).
INSTALLATION
INSTALLATION - SENTRY KEY REMOTE ENTRY MODULE
1. Install the SKREEM module to the base plate.
2. Connect the 18-pin electrical connector and the
2-pin CAN bus connector (1) to the SKREEM.
3. Connect the 2-pin connector for the sentry key
antenna ring.
4. Install the instrument cluster. (Refer to 8 - ELEC-
TRICAL/INSTRUMENT CLUSTER - INSTALLA-
TION).
5. Connect the negative battery cable.
ZH