8O - 60
RESTRAINTS - ELECTRICAL DIAGNOSTICS
PASSENGER SEAT BELT SWITCH CIRCUIT (CONTINUED)
4.
MEASURE THE RESISTANCE OF THE PASSENGER SEAT BELT SWITCH GROUND CIRCUIT
Note: When reconnecting the Airbag System components, the
ignition must be turned off and the battery must be disconnected.
Measure the resistance of the ground circuit at the Passenger Seat
Belt Switch harness connector.
Is the resistance below 5.0 ohms?
Yes
>> Replace the Occupant Restraint Controller. (Refer to 8 -
ELECTRICAL/RESTRAINTS/OCCUPANT
CONTROLLER - REMOVAL).
WARNING: IF THE OCCUPANT RESTRAINT CONTROLLER IS
DROPPED AT ANY TIME, IT MUST BE REPLACED.
Perform AIRBAG VERIFICATION TEST.
No
>> Repair the Passenger Seat Belt Switch ground circuit for
an open.
Perform AIRBAG VERIFICATION TEST.
RESTRAINT
ZH