ZH
LAMP OUTAGE INDICATOR CIRCUIT (CONTINUED)
2.
MEASURE LAMP OUTAGE INDICATOR CIRCUIT RESISTANCE
Turn the ignition off.
Disconnect the Illumination Control Module harness connector.
Note: Check connectors — Clean/repair as necessary.
Measure the resistance of the Lamp Outage Indicator circuit from the
Illumination Control Module D harness connector to the Instrument
Cluster C1 harness connector.
Is the resistance below 5.0 ohms?
Yes
>> Replace the Illumination Control Module.(Refer to 8 -
ELECTRICAL/LAMPS/LIGHTING
LAMP SWITCH - REMOVAL).
Perform BODY VERIFICATION TEST.
No
>> Repair the Lamp Outage Indicator circuit for an open.
Perform BODY VERIFICATION TEST.
INSTRUMENT CLUSTER - ELECTRICAL DIAGNOSTICS 8J - 7
-
EXTERIOR/HEAD-