Chrysler 2005 Crossfire SRT6 Service Manual page 1369

ZH
DRIVER SEAT BELT TENSIONER SQUIB CIRCUIT (CONTINUED)
2.
WITH THE DRB III , READ ACTIVE DTCs
WARNING: TURN THE IGNITION OFF, DISCONNECT THE BAT-
TERY AND WAIT TWO MINUTES BEFORE PROCEEDING.
Disconnect the Driver Seat Belt Tensioner connector.
Note: Check connectors - Clean/repair as necessary.
Connect the appropriate Load Tool to the Driver Seat Belt Tensioner
Squib connector.
WARNING: TURN THE IGNITION ON, THEN RECONNECT THE
BATTERY.
With the DRB III , read the active DTCs.
Does the DRB III display an active Driver Seat Belt Tensioner
Squib DTC?
Yes >> Go to 3
No >> Replace the Driver Seat Belt Tensioner. (Refer to 8 - ELECTRICAL/RESTRAINTS/SEAT BELT &
RETRACTOR - REMOVAL).
Perform AIRBAG VERIFICATION TEST. (Refer to 8 - ELECTRICAL/RESTRAINTS - DIAGNOSIS AND
TESTING).
3.
MEASURE THE RESISTANCE OF THE DRIVER SEAT BELT SQUIB LINE 1 CIRCUIT
WARNING: TURN THE IGNITION OFF, DISCONNECT THE BAT-
TERY AND WAIT TWO MINUTES BEFORE PROCEEDING.
Disconnect the ORC harness connector.
Note: Check connectors - Clean/repair as necessary.
Connect the appropriate harness adapter to the ORC connector.
Disconnect the Load Tool from the Driver Seat Belt Tensioner Squib
connector.
Measure the resistance of the Driver Seat Belt Squib Line 1 circuit
from the ORC connector to the Driver Seat Belt Tensioner Squib con-
nector.
Is the resistance below 1.0 ohm?
Yes >> Go to 4
No >> Repair the Driver Seat Belt Squib Line 1 circuit for an
open.
Perform AIRBAG VERIFICATION TEST. (Refer to 8 -
ELECTRICAL/RESTRAINTS - DIAGNOSIS AND TEST-
ING).
Note: When reconnecting the Airbag System components, the
ignition must be turned off and the battery must be disconnected.
RESTRAINTS - ELECTRICAL DIAGNOSTICS 8O - 13