Chrysler 2005 Crossfire SRT6 Service Manual page 1075

ZH
*LEFT PARK LAMP INOPERATIVE (CONTINUED)
FUSED B(+) CIRCUIT OPEN
GROUND CIRCUIT OPEN
LEFT PARK LAMP BULB
For a complete Exterior Lamps Circuit Diagram, (Refer to 8 - ELECTRICAL/LAMPS/LIGHTING - EXTERIOR -
SCHEMATICS AND DIAGRAMS).
Diagnostic Test
1.
INSPECT THE LEFT PARK LAMP BULB
Note: If the left front side marker lamp, the left park lamp, the left rear side marker lamp, and the left tail
lamp are inoperative, inspect Fuse 10 located in the Illumination Control Module/IP Fuse Block. If the fuse
is open, repair the cause of the open fuse before continuing.
Turn the ignition off.
Remove the Left Park Lamp bulb and inspect for an open filament.
Is the Bulb filament open?
Yes >> Replace the Left Park Lamp bulb. (Refer to 8 - ELECTRICAL/LAMPS/LIGHTING - EXTERIOR/FRONT
POSITION LAMP - REMOVAL).
Perform BODY VERIFICATION TEST.
No >> Go to 2
2.
MEASURE FUSED B(+) CIRCUIT RESISTANCE
Disconnect the Left Park Lamp harness connector.
Disconnect the Illumination Control Module harness connector.
Note: Check connectors - Clean/repair as necessary.
Measure the resistance between the Left Park Lamp harness connec-
tor and the Illumination Control Module harness connector.
Is the resistance below 5.0 ohms?
Yes >> Go to 3
No >> Repair the Fused B(+) circuit for an open between the Left
Park Lamp and the Illumination Control Module.
Perform BODY VERIFICATION TEST.
LAMPS/LIGHTING - EXTERIOR - ELECTRICAL DIAGNOSTICS 8L - 9
POSSIBLE CAUSES