Chrysler 2005 Crossfire SRT6 Service Manual page 1314

8N - 84 POWER SEATS - ELECTRICAL DIAGNOSTICS
*DRIVER POWER SEAT HORIZONTAL MOTOR INOPERATIVE (CONTINUED)
DRIVER POWER SEAT HORIZONTAL MOTOR
DRIVER POWER SEAT HORIZONTAL MOTOR CIRCUIT
DRIVER POWER SEAT SWITCH
For a complete Power Seats Circuit Diagram, (Refer to 8 - ELECTRICAL/POWER SEATS - SCHEMATICS AND
DIAGRAMS).
Diagnostic Test
1.
TEST THE DRIVER POWER SEAT HORIZONTAL MOTOR
Turn the ignition off.
Disconnect the Driver Power Seat Horizontal Motor harness connector.
Note: Check connectors - Clean/repair as necessary.
Connect a jumper wire from B(+) to one cavity of the Driver Power
Seat Horizontal Motor connector (motor side).
Connect a second jumper wire from ground to the other cavity of the
Driver Power Seat Horizontal Motor connector (motor side).
Note seat movement, if no seat movement is noted, reverse the
jumper wires at the Horizontal Motor connector.
Did the Driver Power Seat move backward or forward?
Yes >> Replace the Driver Power Seat Switch. (Refer to 8 -
ELECTRICAL/POWER SEATS/DRIVER SEAT SWITCH -
REMOVAL).
Perform BODY VERIFICATION TEST.
No >> Replace the Driver Power Seat Horizontal Motor. (Refer to 8 - ELECTRICAL/POWER SEATS/HORI-
ZONTAL MOTOR - REMOVAL).
Perform BODY VERIFICATION TEST.
POSSIBLE CAUSES
ZH