Chrysler 2005 Crossfire SRT6 Service Manual page 1076

8L - 10 LAMPS/LIGHTING - EXTERIOR - ELECTRICAL DIAGNOSTICS
*LEFT PARK LAMP INOPERATIVE (CONTINUED)
3.
MEASURE LEFT PARK LAMP VOLTAGE
Connect the Illumination Control Module harness connector.
Turn the ignition on.
Turn the park lamps on.
Measure the voltage between the Left Park Lamp harness connector
cavity 2 and ground.
Is voltage present?
Yes >> Go to 4
No >> Replace the Illumination Control Module. (Refer to 8 -
ELECTRICAL/LAMPS/LIGHTING
LAMP SWITCH - REMOVAL).
Perform BODY VERIFICATION TEST.
4.
MEASURE LEFT PARK LAMP GROUND CIRCUIT RESISTANCE
Turn the ignition off.
Turn the park lamps off.
Measure the resistance between the Left Park Lamp harness connec-
tor cavity 1 and ground.
Is the resistance below 5.0 ohms?
Yes >> Ensure that the Left Park Lamp bulb is installed properly
and replace the bulb socket if necessary.
Perform BODY VERIFICATION TEST.
No >> Repair the Left Park Lamp ground circuit for an open.
Perform BODY VERIFICATION TEST.
- EXTERIOR/HEAD-
ZH