Chrysler 2005 Crossfire SRT6 Service Manual page 1002

8J - 48 INSTRUMENT CLUSTER - ELECTRICAL DIAGNOSTICS
*RIGHT TURN SIGNAL INDICATOR INOPERATIVE (CONTINUED)
INDICATOR CIRCUIT OPEN
INDICATOR LAMP
INSTRUMENT CLUSTER
For a complete Instrument Cluster Circuit Diagram,(Refer to 8 - ELECTRICAL/INSTRUMENT CLUSTER - SCHE-
MATICS AND DIAGRAMS).
Diagnostic Test
1.
INSPECT THE RIGHT TURN SIGNAL INDICATOR LAMP
Turn the ignition off.
Remove the Right Turn Signal Indicator Lamp from the Instrument Cluster and inspect the lamp for an open fila-
ment.
Is the lamp filament open?
Yes >> Replace the Right Turn Signal Indicator Lamp. (Refer to 8 - ELECTRICAL/INSTRUMENT CLUSTER -
STANDARD PROCEDURE).
Perform BODY VERIFICATION TEST.
No >> Go to 2
2.
MEASURE RIGHT TURN SIGNAL INDICATOR CIRCUIT RESISTANCE
With the ignition off.
Disconnect the Remote Keyless Entry Relay.
Disconnect the Instrument Cluster C1 harness connector.
Note: Check connectors - Clean/repair as necessary.
Measure the resistance of the Right Turn Signal Indicator circuit from
the RKE Relay harness connector cavity 5 to the Instrument Cluster
C1 harness connector cavity A10.
Is the resistance below 5.0 ohms?
Yes >> Replace the Instrument Cluster. (Refer to 8 - ELECTRI-
CAL/INSTRUMENT CLUSTER - REMOVAL).
Perform BODY VERIFICATION TEST.
No >> Repair the Right Turn Signal Indicator Driver circuit for an
open.
Perform BODY VERIFICATION TEST.
POSSIBLE CAUSES
ZH