Chrysler 2005 Crossfire SRT6 Service Manual page 1331

ZH
3. Install the rear riser motor front attachment bolt (1).
Tighten the bolt to 4 N·m (35 in. lbs.).
4. Connect the rear riser motor harness connector.
Note: Insure the harness is routed and secured in
its original position to avoid potential interference
with moving parts.
5. Install the front seat. (Refer to 23 - BODY/SEATS/
SEAT - INSTALLATION).
6. Connect the negative battery cable.
HORIZONTAL AND FRONT RISER MOTORS
REMOVAL
REMOVAL - HORIZONTAL MOTOR
1. Remove the front seat. (Refer to 23 - BODY/
SEATS/SEAT - REMOVAL).
2. Disconnect the horizontal motor harness connector
(1).
POWER SEATS - SERVICE INFORMATION 8N - 101