Chrysler 2005 Crossfire SRT6 Service Manual page 1008

8J - 54 INSTRUMENT CLUSTER - ELECTRICAL DIAGNOSTICS
*BRAKE WARNING INDICATOR INOPERATIVE (CONTINUED)
2.
MEASURE BRAKE WARNING INDICATOR CIRCUIT RESISTANCE
Turn the ignition off.
Disconnect the Instrument Cluster C1 harness connector.
Note: Check connectors - Clean/repair as necessary.
Connect a jumper wire between cavity 1 and cavity 2 of the Brake
Fluid Level Switch harness connector.
Measure the resistance between ground and the Brake Warning Indi-
cator circuit.
Is the resistance below 5.0 ohms?
Yes >> Check the Brake Warning Indicator lamp. If the lamp is
OK, replace the Instrument Cluster. (Refer to 8 - ELEC-
TRICAL/INSTRUMENT CLUSTER - REMOVAL).
Perform BODY VERIFICATION TEST.
No >> Repair the Brake Warning Indicator circuit for an open.
Perform BODY VERIFICATION TEST.
ZH