Chrysler 2005 Crossfire SRT6 Service Manual page 1494

8O - 138 RESTRAINTS - SERVICE INFORMATION
6. Reinstall the carpet (1) in the upper corner area.
7. Position the plastic cover (3) over the seat belt.
8. Install the screws (1) attaching the plastic cover (3)
to the door opening.
9. Install the door edge guard (2).
10. Install the bolt (1) on the belt end attaching it to
the seat. Tighten to 35 N·m (26 ft. lbs.).
11. Install the plastic bolt cover over the seat belt bolt.
12. Do not reconnect the negative battery cable at
this time. Perform the Supplemental Restraint
System verification test procedure after servicing
any Supplemental Restraint System component.
(Refer to 8 - ELECTRICAL/RESTRAINTS - STAN-
DARD PROCEDURE).
ZH