Chrysler 2005 Crossfire SRT6 Service Manual page 1473

ZH
9. Tilt the seat back, to gain access to the bottom of
the seat.
10. Disconnect the power seat harness connectors.
11. Carefully remove the seat from the vehicle.
12. Remove the carpet retainer button (1) at the pas-
senger compartment rear wall.
Note: Do not pry on the carpet retainer button, the
button will unscrew from the fastener.
13. Fold back the carpet near the center of the door
sill to gain access to the side impact sensor.
Note: The carpet is firmly molded, and will need to
be propped up while servicing the impact sensor.
14. Disconnect the side impact sensor harness con-
nector (2).
CAUTION: Use caution when disconnecting the
squib connector. Do not pry on the connector
insulator to disengage the connector from the side
impact sensor. Improper removal of the connector
can result in damage to the airbag circuits or con-
nector insulator.
15. Remove the two bolts (1) attaching the side
impact sensor to the body cross brace.
16. Remove the side impact sensor from the vehicle.
RESTRAINTS - SERVICE INFORMATION 8O - 117