Chrysler 2005 Crossfire SRT6 Service Manual page 1347

ZH
*RIGHT FRONT POWER WINDOW INOPERATIVE (CONTINUED)
5.
TEST THE RIGHT FRONT POWER WINDOW MOTOR
Turn the ignition off.
Disconnect the Body Control Module (BCM) harness connector.
Note: Check connectors - Clean/repair as necessary.
Connect a fused jumper wire from cavity 10 of the BCM C4 harness
connector to B(+).
Connect a second fused jumper wire to cavity 11 of the BCM C4 har-
ness connector and momentarily connect the jumper to ground.
Note the window movement; if the Right front window does not move,
reverse the jumper wires at the B(+) and ground connections.
Did the Right front window move upward or downward?
Yes >> Replace the Body Control Module. (Refer to 8 - ELECTRI-
CAL/ELECTRONIC CONTROL MODULES/BODY CON-
TROL/CENTRAL TIMER MODULE - REMOVAL).
Perform BODY VERIFICATION TEST.
No >> Go to 6
6.
MEASURE RIGHT FRONT POWER WINDOW DRIVER MOTOR CIRCUIT RESISTANCE
With the ignition off.
Disconnect the Right Front Power Window Motor harness connector.
Note: Check connectors - Clean/repair as necessary.
Connect a jumper wire between cavity 1 and cavity 2 of the Right
Front Power Window Motor harness connector.
Measure the resistance between cavity 10 and cavity 11 of the BCM
C4 harness connector.
Is the resistance below 5.0 ohms?
Yes >> Replace the Right Front Power Window Motor. (Refer to 8
- ELECTRICAL/POWER WINDOWS/WINDOW MOTOR -
REMOVAL).
Perform BODY VERIFICATION TEST.
No >> Repair the Right Front Power Window Drive circuit(s) for
an open.
Perform BODY VERIFICATION TEST.
POWER WINDOWS - ELECTRICAL DIAGNOSTICS 8N - 117