Chrysler 2005 Crossfire SRT6 Service Manual page 1251

ZH
DOOR LOCK/DOOR UNLOCK SWITCH SENSE CIRCUIT (CONTINUED)
When Monitored and Set Condition
• When Monitored: Continuous.
• Set Condition: The Central Locking Pump/Security System Module (CLP/SSM) reports a short to power,
ground, or an open circuit failure that is detected between the Body Control Module (BCM) and the Sentry Key
Remote Entry Module (SKREEM) on the Door Lock/Unlock Switch Sense circuit.
DOOR LOCK/UNLOCK SWITCH SENSE CIRCUIT SHORTED TO VOLTAGE
DOOR LOCK/UNLOCK SWITCH SENSE CIRCUITS SHORTED TOGETHER
DOOR LOCK/UNLOCK SWITCH SENSE CIRCUIT SHORTED TO GROUND
DOOR LOCK/UNLOCK SWITCH SENSE CIRCUIT OPEN
BODY CONTROL MODULE INTERNAL FAILURE
For a complete Power Locks Circuit Diagram, (Refer to 8 - ELECTRICAL/POWER LOCKS - SCHEMATICS AND
DIAGRAMS).
Diagnostic Test
1.
MEASURE THE RESISTANCE OF THE DOOR LOCK SWITCH SENSE CIRCUIT
Turn the ignition off.
Disconnect the BCM harness connector.
Disconnect the SKREEM C1 harness connector.
Note: Check connectors - Clean/repair as necessary.
Measure the resistance of the Door Lock Switch Sense circuit from the
BCM harness connector to the SKREEM harness connector.
Is the resistance below 5.0 ohms?
Yes >> Go to 2
No >> Repair the Door Lock Switch Sense circuit for an open.
Perform BODY VERIFICATION TEST.
POWER LOCKS - ELECTRICAL DIAGNOSTICS 8N - 21
POSSIBLE CAUSES