Chrysler 2005 Crossfire SRT6 Service Manual page 988

8J - 34 INSTRUMENT CLUSTER - ELECTRICAL DIAGNOSTICS
NO CAN COMMUNICATIONS WITH CAB (CONTINUED)
12.
INTERMITTENT WIRING AND CONNECTORS
The conditions necessary to set this DTC are not present at this time.
Note: Check connectors — Clean/repair as necessary. Poor pin to terminal connections can set DTCs.
Note: Check for any Technical Service Bulletins that may apply.
Using the wiring diagram/schematic as a guide, inspect the wiring and connectors specific to this DTC. Wiggle the
wires while checking for shorts and/or open circuits.
Were there any problems found?
Yes >> Repair as necessary.
Perform POWERTRAIN VERIFICATION TEST VER.
No >> The condition that caused this DTC to set is currently not present. Inspect the related wiring harness for
a possible intermittent condition.
ZH