Chrysler 2005 Crossfire SRT6 Service Manual page 882

8G - 22 HEATED MIRRORS - ELECTRICAL DIAGNOSTICS
*RIGHT HEATED MIRROR INOPERATIVE (CONTINUED)
RIGHT MIRROR HEATER ELEMENT FUSED HEATED MIRROR SUPPLY CIRCUIT OPEN
RIGHT MIRROR HEATER ELEMENT GROUND CIRCUIT OPEN
RIGHT MIRROR HEATER ELEMENT
For a complete Heated Mirrors Circuit Diagram (Refer to 8 - ELECTRICAL/HEATED MIRRORS - SCHEMATICS
AND DIAGRAMS).
Diagnostic Test
1.
MEASURE RIGHT MIRROR HEATER ELEMENT FUSED HEATED MIRROR SUPPLY CIRCUIT VOLTAGE
Turn the ignition off.
Disconnect the Right Power Mirror harness connector.
Note: Check connector - Clean/repair as necessary.
Turn the ignition on.
Activate the rear window defogger.
Measure the voltage of the Fused Heated Mirror Supply circuit at the
Right Power Mirror harness connector.
Is the voltage above 10 volts?
Yes >> Go to 2
No >> Repair the Fused Heated Mirror Supply circuit for an open.
Perform BODY VERIFICATION TEST.
2.
MEASURE RIGHT MIRROR HEATER ELEMENT GROUND CIRCUIT RESISTANCE
Turn the ignition off.
Measure the resistance between ground and the Right Mirror Heater
Element Ground circuit.
Is the resistance below 5.0 ohms?
Yes >> Replace the Right Power Mirror. (Refer to 8 - ELECTRI-
CAL/POWER
REMOVAL).
Perform BODY VERIFICATION TEST.
No >> Repair the Right Mirror Heater Element Ground circuit for
an open.
Perform BODY VERIFICATION TEST.
POSSIBLE CAUSES
MIRRORS/SIDEVIEW MIRROR -
ZH