Chrysler 2005 Crossfire SRT6 Service Manual page 1452

8O - 96 RESTRAINTS - SERVICE INFORMATION
Note: If the clockspring is to be reused, be certain to secure the clockspring rotor to the clockspring case
to maintain clockspring centering until it is reinstalled on the steering column. If clockspring centering is
not maintained, the clockspring must be centered again before it is reinstalled. (Refer to 8 - ELECTRICAL/
RESTRAINTS/CLOCKSPRING - STANDARD PROCEDURE).
INSTALLATION
1. Install the steering angle sensor to the clockspring
using the alignment points on the housings (1).
(Refer to 5 - BRAKES/ELECTRICAL/STEERING
ANGLE SENSOR - INSTALLATION).
Note: If the clockspring is being reused, be certain
to remove anything securing the clockspring rotor
to the clockspring case that was used to maintain
clockspring centering until reinstallation on the
steering column. If clockspring centering was not
maintained, the clockspring must be centered
again before it is installed. (Refer to 8 - ELECTRI-
CAL/RESTRAINTS/CLOCKSPRING
PROCEDURE).
2. Install the clockspring to the steering column.
3. Install the two screws (1) that secure the clock-
spring to the steering column housing. Tighten the
clockspring screws 1 N·m (9 in. lbs.).
- STANDARD
ZH