Chrysler 2005 Crossfire SRT6 Service Manual page 1073

ZH
*RIGHT FOG LAMP INOPERATIVE (CONTINUED)
3.
MEASURE RIGHT FOG LAMP VOLTAGE
Connect the Illumination Control Module harness connector.
Turn the ignition on.
Turn the fog lamps on.
Measure the voltage between the Right Fog Lamp harness connector
cavity 2 and ground.
Is the voltage above 10 volts?
Yes >> Go to 4
No >> Replace the Illumination Control Module. (Refer to 8 -
ELECTRICAL/LAMPS/LIGHTING
LAMP SWITCH - REMOVAL).
Perform BODY VERIFICATION TEST.
4.
MEASURE RIGHT FOG LAMP GROUND CIRCUIT RESISTANCE
Turn the ignition off.
Turn the fog lamps off.
Measure the resistance between the Right Fog Lamp harness connec-
tor cavity 1 and ground.
Is the resistance below 5.0 ohms?
Yes >> Ensure that the Right Fog Lamp bulb is installed properly
and replace the bulb socket if necessary.
Perform BODY VERIFICATION TEST.
No >> Repair the Right Fog Lamp ground circuit for an open.
Perform BODY VERIFICATION TEST.
LAMPS/LIGHTING - EXTERIOR - ELECTRICAL DIAGNOSTICS 8L - 7
- EXTERIOR/HEAD-