Chrysler 2005 Crossfire SRT6 Service Manual page 719

ZH
*NO RESPONSE FROM OCCUPANT RESTRAINT CONTROLLER (CONTINUED)
6.
SCI TRANSMIT CIRCUIT SHORTED TO VOLTAGE
Turn the ignition on.
Measure the voltage of the SCI Transmit circuit at the ORC connector.
Is the voltage below 0.5 volt?
Yes >> Replace the Occupant Restraint Controller. (Refer to 8 -
ELECTRICAL/RESTRAINTS/OCCUPANT
CONTROLLER - REMOVAL).
WARNING: IF THE OCCUPANT RESTRAINT CONTROLLER IS
DROPPED AT ANY TIME, IT MUST BE REPLACED.
WARNING: WHEN RECONNECTING AIRBAG SYSTEM COMPO-
NENTS, THE IGNITION MUST BE TURNED OFF AND THE BAT-
TERY MUST BE DISCONNECTED FOR TWO MINUTES.
Perform AIRBAG VERIFICATION TEST.
No >> Repair the SCI Transmit circuit for a short to voltage.
WARNING: WHEN RECONNECTING AIRBAG SYSTEM COMPONENTS, THE IGNITION MUST BE TURNED OFF
AND THE BATTERY MUST BE DISCONNECTED FOR TWO MINUTES.
Perform AIRBAG VERIFICATION TEST.
ELECTRONIC CONTROL MODULES - ELECTRICAL DIAGNOSTICS 8E - 17
RESTRAINT