Chrysler 2005 Crossfire SRT6 Service Manual page 1528

8Q - 22 VEHICLE THEFT SECURITY - ELECTRICAL DIAGNOSTICS
DOOR UNLOCK SWITCH SENSE CIRCUIT (CONTINUED)
2.
MEASURE THE VOLTAGE OF THE DOOR UNLOCK SWITCH SENSE CIRCUIT
Turn the ignition on.
Measure the voltage of the Door Unlock Switch Sense circuit at the
SKREEM harness connector.
Is voltage present?
Yes >> Repair the Door Unlock Switch Sense circuit for a short to
voltage.
Perform VTSS VERIFICATION TEST.
No >> Go to 3
3.
MEASURE THE RESISTANCE OF THE DOOR UNLOCK SWITCH SENSE CIRCUIT
Turn the ignition off.
Measure the resistance between ground and the Door Unlock Switch
Sense circuit at the SKREEM harness connector.
Is the resistance below 10K ohms?
Yes >> Repair the Door Unlock Switch Sense circuit for a short to
ground.
Perform VTSS VERIFICATION TEST.
No >> Replace the Sentry Key Remote Entry Module. (Refer to 8
- ELECTRICAL/VEHICLE THEFT SECURITY/SENTRY
KEY REMOTE ENTRY MODULE - REMOVAL).
Perform VTSS VERIFICATION TEST.
ZH