Chrysler 2005 Crossfire SRT6 Service Manual page 852

8F - 40 STARTING SYSTEM
3. Connect the voltmeter (2) to measure between the
battery (1) positive terminal post and the starter (3)
solenoid battery terminal stud. Rotate and hold the
ignition switch in the Start position. Observe the
voltmeter. If the reading is above 0.2 volt, clean
and tighten the battery cable connection at the
solenoid. Repeat the test. If the reading is still
above 0.2 volt, replace the faulty battery positive
cable.
4. Connect the voltmeter (1) to measure between the
battery (2) negative terminal post and a good clean
ground on the engine block (3). Rotate and hold
the ignition switch in the Start position. Observe the
voltmeter. If the reading is above 0.2 volt, clean
and tighten the battery negative cable attachment
on the engine block. Repeat the test. If the reading
is still above 0.2 volt, replace the faulty battery
negative cable.
5. Connect the positive lead of the voltmeter (3) to the
starter (1) housing. Connect the negative lead of
the voltmeter to the battery (2) negative terminal
post. Rotate and hold the ignition switch in the
Start position. Observe the voltmeter. If the reading
is above 0.2 volt, correct the poor starter to engine
block ground contact.
ZH