Chrysler 2005 Crossfire SRT6 Service Manual page 1365

ZH
DRIVER AIRBAG SQUIB CIRCUIT (CONTINUED)
9.
MEASURE THE RESISTANCE OF THE DRIVER SQUIB LINE 1 CIRCUIT
With the ignition on.
Measure the resistance between ground and the Driver Squib Line 1
circuit.
Is the resistance below 10K ohms?
Yes >> Repair the Driver Squib Line 1 circuit for a short to ground.
Perform AIRBAG VERIFICATION TEST.
Note: When reconnecting the Airbag System components, the
ignition must be turned off and the battery must be disconnected.
No >> Go to 10
10.
MEASURE THE RESISTANCE OF THE DRIVER SQUIB LINE 2 CIRCUIT
With the ignition on.
Measure the resistance between ground and the Driver Squib Line 2
circuit.
Is the resistance below 10K ohms?
Yes >> Repair the Driver Squib Line 2 circuit for a short to ground.
Perform AIRBAG VERIFICATION TEST.
Note: When reconnecting the Airbag System components, the
ignition must be turned off and the battery must be disconnected.
No >> Replace the Occupant Restraint Controller. (Refer to 8 -
ELECTRICAL/RESTRAINTS/OCCUPANT
CONTROLLER - REMOVAL).
WARNING: IF THE OCCUPANT RESTRAINT CONTROLLER IS
DROPPED AT ANY TIME, IT MUST BE REPLACED.
Perform AIRBAG VERIFICATION TEST.
RESTRAINTS - ELECTRICAL DIAGNOSTICS 8O - 9
RESTRAINT