Chrysler 2005 Crossfire SRT6 Service Manual page 1298

8N - 68 POWER MIRRORS - SERVICE INFORMATION
AUTOMATIC DAY / NIGHT MIRROR
DESCRIPTION
An Automatic Day/Night Rear View Mirror System is
standard on this model. It is a completely self-con-
tained unit (2) which is located at the top and center
of the windshield. The mirror sensitivity cannot be
repaired or adjusted; if any components of the mirror
unit itself are faulty or damaged, the entire automatic
day/night inside rear view mirror assembly must be
replaced.
OPERATION
A thin layer of electrochromatic material between two pieces of conductive glass make up the face of the mirror. The
system will automatically change the reflectance of the inside rear view mirror to protect the driver from the
unwanted headlight glare of trailing vehicles while driving at night. The self-dimming feature is defeated if the interior
lights are switched on, or the system senses the backup light circuit is energized whenever the transmission is
shifted into reverse.
REMOVAL
1. Disconnect the negative battery cable.
2. Insert a 5 mm metal dowel into the hole on the
windshield side of the mirror base.
3. Rotate the mirror base approximately 90 degrees
to the left or right.
4. Remove the courtesy lamp. (Refer to 8 - ELECTRI-
CAL/LAMPS/LIGHTING - INTERIOR/COURTESY
LAMP SWITCH - REMOVAL).
5. Disconnect the mirror harness connector.
6. Feed the harness connector and harness past the
opening in the headliner and remove the mirror
assembly.
ZH