Chrysler 2005 Crossfire SRT6 Service Manual page 957

ZH
COOLANT LEVEL SENSOR/WASHER FLUID LEVEL SWITCH CIRCUIT (CONTINUED)
When Monitored and Set Condition
• When Monitored: With the ignition on.
• Set Condition: Coolant Level Sensor/Washer Fluid Level Switch circuit failure.
INDICATOR CIRCUIT OPEN
COOLANT LEVEL SENSOR MALFUNCTION
WASHER FLUID LEVEL SWITCH MALFUNCTION
INDICATOR LAMP
INSTRUMENT CLUSTER
For a complete Instrument Cluster Circuit Diagram, (Refer to 8 - ELECTRICAL/INSTRUMENT CLUSTER - SCHE-
MATICS AND DIAGRAMS).
Diagnostic Test
1.
INSPECT THE LOW COOLANT INDICATOR LAMP
Turn the ignition off.
Remove the Low Coolant Indicator Lamp from the Instrument Cluster and inspect the lamp for an open filament.
Is the lamp filament open?
Yes >> Replace the Low Coolant Indicator Lamp. (Refer to 8 - ELECTRICAL/INSTRUMENT CLUSTER - STAN-
DARD PROCEDURE).
Perform BODY VERIFICATION TEST.
No >> Go to 2
2.
INSPECT THE LOW WASHER FLUID INDICATOR LAMP
With the ignition off.
Remove the Low Washer Fluid Indicator Lamp from the Instrument Cluster and inspect the lamp for an open fila-
ment.
Is the lamp filament open?
Yes >> Replace the Low Washer Fluid Indicator Lamp. (Refer to 8 - ELECTRICAL/INSTRUMENT CLUSTER -
STANDARD PROCEDURE).
Perform BODY VERIFICATION TEST.
No >> Go to 3
3.
MEASURE COOLANT LEVEL SENSOR RESISTANCE
With the ignition off.
Disconnect the Coolant Level Sensor harness connector.
Note: Check connectors - Clean/repair as necessary.
Measure the resistance between cavity 1 and cavity 2 of the Coolant
Level Sensor connector.
Is the resistance between 102 and 120 ohms?
Yes >> Go to 4
No >> Replace the Coolant Level Sensor. (Refer to 7 - COOL-
ING/ENGINE/COOLANT LEVEL SENSOR - REMOVAL).
Perform BODY VERIFICATION TEST.
INSTRUMENT CLUSTER - ELECTRICAL DIAGNOSTICS 8J - 3
POSSIBLE CAUSES