Chrysler 2005 Crossfire SRT6 Service Manual page 765

ZH
*NO RESPONSE FROM SENTRY KEY REMOTE ENTRY MODULE (CONTINUED)
5.
GROUND CIRCUIT OPEN
Turn the ignition off.
Measure the resistance of the Ground circuit from the SKREEM C1
harness connector.
Is the resistance below 5.0 ohms?
Yes >> Go to 6
No >> Repair the Ground circuit for an open.
Perform BODY VERIFICATION TEST.
6.
SCI TRANSMIT CIRCUIT OPEN
With the ignition off.
Measure the resistance of the SCI Transmit circuit from the SKREEM
C1 harness connector to the DLC.
Is the resistance below 5.0 ohms?
Yes >> Replace the Sentry Key Remote Entry Module. (Refer to 8
- ELECTRICAL/ELECTRONIC CONTROL MODULES/EN-
TRY MODULE - REMOVAL).
Perform BODY VERIFICATION TEST.
No >> Repair the SCI Transmit circuit for an open.
Perform BODY VERIFICATION TEST.
ELECTRONIC CONTROL MODULES - ELECTRICAL DIAGNOSTICS 8E - 63