Chrysler 2005 Crossfire SRT6 Service Manual page 1289

ZH
*BOTH POWER MIRRORS INOPERATIVE (CONTINUED)
FUSED B(+) CIRCUIT
POWER MIRROR SWITCH GROUND CIRCUIT OPEN
POWER MIRROR SWITCH
For a complete Power Mirrors Circuit Diagram, (Refer to 8 - ELECTRICAL/POWER MIRRORS - SCHEMATICS AND
DIAGRAMS).
Diagnostic Test
1.
MEASURE POWER MIRROR SWITCH FUSED B(+) CIRCUIT VOLTAGE
Note: Inspect Fuse 6 located in the Underhood Accessory Fuse Block. If the fuse is open, repair the cause
of the open fuse before continuing.
Turn the ignition off.
Disconnect the Power Mirror Switch harness connector.
Note: Check connectors - Clean/repair as necessary.
Turn the ignition on.
Measure the voltage of the Fused B(+) circuit at the Power Mirror
Switch harness connector.
Is the voltage above 10 volts?
Yes >> Go to 2
No >> Repair the Power Mirror Switch Fused B(+) circuit for an
open.
Perform BODY VERIFICATION TEST.
2.
MEASURE POWER MIRROR SWITCH GROUND CIRCUIT RESISTANCE
Turn the ignition off.
Measure the resistance between ground and the Power Mirror Switch
harness connector.
Is the resistance below 5.0 ohms?
Yes >> Replace the Power Mirror Switch. (Refer to 8 - ELECTRI-
CAL/POWER MIRRORS/POWER MIRROR SWITCH -
REMOVAL).
Perform BODY VERIFICATION TEST.
No >> Repair the Ground circuit between the Power Mirror
Switch harness connector and ground for an open.
Perform BODY VERIFICATION TEST.
POWER MIRRORS - ELECTRICAL DIAGNOSTICS 8N - 59
POSSIBLE CAUSES