Chrysler 2005 Crossfire SRT6 Service Manual page 963

ZH
FUEL LEVEL SENSOR CIRCUIT (CONTINUED)
When Monitored and Set Condition
• When Monitored: With the ignition on.
• Set Condition: Fuel Level Sensor circuit failure between the Fuel Level Sensor and the Instrument Cluster.
FUEL LEVEL SENSOR CIRCUIT(S) OPEN
FUEL LEVEL SENSOR
INSTRUMENT CLUSTER
For a complete Instrument Cluster Circuit Diagram, (Refer to 8 - ELECTRICAL/INSTRUMENT CLUSTER - SCHE-
MATICS AND DIAGRAMS).
Diagnostic Test
1.
MEASURE FUEL LEVEL SENSOR CIRCUIT VOLTAGE
Turn the ignition off.
Disconnect the Fuel Level Sensor harness connector.
Note: Check connectors - Clean/repair as necessary.
Turn the ignition on.
Measure the voltage between cavity 1 and cavity 2 of the Fuel Level
Sensor harness connector.
Is the voltage approximately .7 of a volt?
Yes >> Replace the Fuel Level Sensor. (Refer to 14 - FUEL SYS-
TEM/FUEL DELIVERY/FUEL LEVEL SENDING UNIT /
SENSOR - REMOVAL).
Perform BODY VERIFICATION TEST.
No >> Go to 2
INSTRUMENT CLUSTER - ELECTRICAL DIAGNOSTICS 8J - 9
POSSIBLE CAUSES