8R - 44
WIPERS/WASHERS - SERVICE INFORMATION
WASHER PUMP MOTOR
REMOVAL
1. Remove the washer reservoir (3). (Refer to 8 -
ELECTRICAL/WIPERS/WASHERS/WASHER RES-
ERVOIR - REMOVAL)
2. Carefully pry upward on the body of the washer
pump motor (1) and pull it out of the rubber grom-
met (2).
INSTALLATION
1. Insert the washer pump motor (1) into the rubber
grommet (2) at the base of the washer reservoir
(3).
2. Press the washer pump motor downward until fully
seated.
3. Install the washer reservoir. (Refer to 8 - ELECTRI-
CAL/WIPERS/WASHERS/WASHER RESERVOIR -
INSTALLATION).
ZH