Chrysler 2005 Crossfire SRT6 Service Manual page 1579

ZH
*WASHERS INOPERATIVE (CONTINUED)
3.
MEASURE RESISTANCE ACROSS MULTI-FUNCTION SWITCH
Note: If any BCM DTCs are set, diagnose them first before con-
tinuing.
Turn the ignition off.
Disconnect the Multi-Function Switch harness connector.
Note: Check connectors - Clean/repair as necessary.
Depress the washer switch, and measure the resistance between cav-
ity 8 and cavity 11 of the Multi-Function Switch.
Is the resistance below 5.0 ohms?
Yes >> Repair the Washer Pump Motor Control circuit for an
open.
Perform BODY VERIFICATION TEST.
No >> Replace the Multi-Function Switch. (Refer to 8 - ELECTRI-
CAL/LAMPS/LIGHTING - EXTERIOR/MULTI-FUNCTION
SWITCH - REMOVAL)
Perform BODY VERIFICATION TEST.
WIPERS/WASHERS - ELECTRICAL DIAGNOSTICS 8R - 9