Chrysler 2005 Crossfire SRT6 Service Manual page 1467

ZH
3. Rotate the base plate and install it over the mount-
ing studs on the floor panel.
Note: Be sure not to pinch or cause interference
with the wiring harnesses while locating the base
plate to the floor mounting studs.
4. Install the plastic retaining nuts (1) and secure the
base plate to the vehicle floor.
5. Install the foam insulating panel.
6. Install the carpeting in the passenger footwell.
7. Install the floor mat to the carpet.
8. Do not reconnect the negative battery cable at this
time. Perform the Supplemental Restraint System
verification test procedure after servicing any Sup-
plemental Restraint System component. (Refer to 8
- ELECTRICAL/RESTRAINTS
PROCEDURE).
RESTRAINTS - SERVICE INFORMATION 8O - 111
- STANDARD