Chrysler 2005 Crossfire SRT6 Service Manual page 1481

ZH
REMOVAL
1. Before attempting any service procedure refer to
the warnings at the beginning of this section.
(Refer to 8 - ELECTRICAL/RESTRAINTS - WARN-
ING).
2. Disconnect the negative battery cable (2). Wait two
minutes for the system capacitor to discharge
before further service.
3. Remove the ignition key.
4. Remove the door trim panel. (Refer to 23 - BODY/
DOOR - FRONT/TRIM PANEL - REMOVAL).
5. Disconnect the side impact airbag squib harness
connector (2) from the side impact airbag.
CAUTION: Do not pull on the squib connector
wires or pry on the connector insulator to disen-
gage the connector from the side airbag inflator
connector receptacle. Improper removal of the
squib wires and their connector insulators can
result in damage to the airbag circuits or connec-
tor insulators.
6. Drill out the mounting rivets (1) for the side impact
airbag.
7. Remove the side impact airbag from the door.
WARNING: DO NOT PLACE AN INTACT UNDE-
PLOYED AIRBAG FACE DOWN ON A HARD SUR-
FACE, THE AIRBAG WILL PROPEL INTO THE AIR
IF ACCIDENTALLY DEPLOYED.
INSTALLATION
WARNING: DISABLE THE SUPPLEMENTAL RESTRAINT SYSTEM BEFORE ATTEMPTING ANY STEERING
WHEEL, STEERING COLUMN, DRIVER AIRBAG, PASSENGER AIRBAG, FRONT IMPACT SENSOR, SIDE
IMPACT SENSOR, SIDE CURTAIN AIRBAG, OR INSTRUMENT PANEL COMPONENT DIAGNOSIS OR SER-
VICE. DISCONNECT AND ISOLATE THE BATTERY NEGATIVE (GROUND) CABLE, THEN WAIT TWO MINUTES
FOR THE SYSTEM CAPACITOR TO DISCHARGE BEFORE PERFORMING FURTHER DIAGNOSIS OR SER-
VICE. THIS IS THE ONLY SURE WAY TO DISABLE THE SUPPLEMENTAL RESTRAINT SYSTEM. FAILURE TO
TAKE THE PROPER PRECAUTIONS COULD RESULT IN ACCIDENTAL AIRBAG DEPLOYMENT AND POSSI-
BLE PERSONAL INJURY.
RESTRAINTS - SERVICE INFORMATION 8O - 125