Chrysler 2005 Crossfire SRT6 Service Manual page 1088

8L - 22 LAMPS/LIGHTING - EXTERIOR - ELECTRICAL DIAGNOSTICS
*LEFT LOW BEAM HEADLAMP INOPERATIVE (CONTINUED)
3.
MEASURE LEFT LOW BEAM HEADLAMP VOLTAGE
Connect the Illumination Control Module harness connector.
Turn the ignition on.
Turn the low beam headlamps on.
Measure the voltage between the Left Front Lamp Assembly harness
connector cavity 3 and ground.
Is the voltage above 10 volts?
Yes >> Go to 4
No >> Replace the Illumination Control Module. (Refer to 8 -
ELECTRICAL/LAMPS/LIGHTING
LAMP SWITCH - REMOVAL).
Perform BODY VERIFICATION TEST.
4.
MEASURE LEFT LOW BEAM HEADLAMP GROUND CIRCUIT RESISTANCE
Turn the ignition off.
Turn the low beam headlamps off.
Measure the resistance between the Left Front Lamp Assembly har-
ness connector cavity 2 and ground.
Is the resistance below 5.0 ohms?
Yes >> Ensure that the Left Low Beam Headlamp bulb is installed
properly and replace the bulb socket if necessary.
Perform BODY VERIFICATION TEST.
No >> Repair the Left Front Lamp Assembly ground circuit for an
open.
Perform BODY VERIFICATION TEST.
- EXTERIOR/HEAD-
ZH