Chrysler 2005 Crossfire SRT6 Service Manual page 1370

8O - 14 RESTRAINTS - ELECTRICAL DIAGNOSTICS
DRIVER SEAT BELT TENSIONER SQUIB CIRCUIT (CONTINUED)
4.
MEASURE THE RESISTANCE OF THE DRIVER SEAT BELT SQUIB LINE 2 CIRCUIT
With the ignition off.
Measure the resistance of the Driver Seat Belt Squib Line 2 circuit
from the ORC connector to the Driver Seat Belt Tensioner Squib con-
nector.
Is the resistance below 1.0 ohm?
Yes >> Go to 5
No >> Repair the Driver Seat Belt Squib Line 2 circuit for an
open.
Perform AIRBAG VERIFICATION TEST. (Refer to 8 -
ELECTRICAL/RESTRAINTS - DIAGNOSIS AND TEST-
ING).
Note: When reconnecting the Airbag System components, the
ignition must be turned off and the battery must be disconnected.
5.
MEASURE THE RESISTANCE OF THE DRIVER SEAT BELT SQUIB CIRCUITS
With the ignition off.
Measure the resistance between the Driver Seat Belt Squib Line 1 cir-
cuit and the Driver Seat Belt Squib Line 2 circuit at the Driver Seat
Belt Tensioner Squib connector.
Is the resistance below 10K ohms?
Yes >> Repair the Driver Seat Belt Squib circuits for a short to
each other.
Perform AIRBAG VERIFICATION TEST. (Refer to 8 -
ELECTRICAL/RESTRAINTS - DIAGNOSIS AND TEST-
ING).
Note: When reconnecting the Airbag System components, the
ignition must be turned off and the battery must be disconnected.
No >> Go to 6
6.
MEASURE THE VOLTAGE OF THE DRIVER SEAT BELT SQUIB LINE 1 CIRCUIT
WARNING: TURN THE IGNITION ON, THEN RECONNECT THE
BATTERY.
Measure the voltage of the Driver Seat Belt Squib Line 1 circuit at the
Squib connector.
Is voltage present?
Yes >> Repair the Driver Seat Belt Squib Line 1 circuit for a short
to voltage.
Perform AIRBAG VERIFICATION TEST. (Refer to 8 -
ELECTRICAL/RESTRAINTS - DIAGNOSIS AND TEST-
ING).
Note: When reconnecting the Airbag System components, the
ignition must be turned off and the battery must be disconnected.
No >> Go to 7
ZH